JVC TM-H150CG/E

(No.YA068)1-25
[CONTROL BLOCK]
4.9 INITIAL SETTING VALUE OF LANDING MENU
Item. Contents Variable range Initial value
C01 DESTINATION 000 ~ 129 001(US/EU)
C02
BRIGHT POINT
UPPER 000 ~ 255 016
C03 LOWER 000 ~ 255 026
C04
CONTRAST POINT
UPPER 000 ~ 127 016
C05 LOWER 000 ~ 127 026
C06
CHROMA POINT
UPPER 000 ~ 127 040
C07 LOWER 000 ~ 127 040
C08
PHASE POINT
UPPER 000 ~ 127 040
C09 LOWER 000 ~ 127 040
C10 OSD HORIZONTAL POSITION 000 ~ 010 000
C11 OSD VERTICAL FREQUENCY 50Hz 000 ~ 010 004
C12 OSD VERTICAL FREQUENCY 60Hz 000 ~ 010 002
C13 HORIZONTAL CENTER (RGB) -128 ~ 000 ~ +127 +007
C14 HORIZONTAL CENTER (COMPONENT) -128 ~ 000 ~ +127 +002
C15 BRIGHT SERVICE 000 ~ 127 000
C16 SHARPNESS CENTER 000 ~ 127 028
C17 HVT H 000 ~ 007 007
C18 HVT V 000 ~ 007 003
C19 HVT H (UNDER SCAN) 000 ~ 007 004
C20 HVT V (UNDER SCAN) 000 ~ 007 002
C21 V-SS.CR 000 ~ 015 005
C22 TRAPEZOID 000 ~ 127 068
C23 HOUR METER 001 ~ 650 001
C24 RUSH DELAY 000 ~ 255 032
C25 DEGAUSS DELAY TIME 000 ~ 255 011
C26 SLOT IDENTIFY 000 ~ 255 000
C27 SLOT IDENTIFY 000 ~ 255 066
C28 SLOT IDENTIFY 000 ~ 255 000
C29 SLOT IDENTIFY 000 ~ 255 001
C30 SLOT IDENTIFY 000 ~ 255 000
C31 SLOT IDENTIFY 000 ~ 255 000
C32 SLOT IDENTIFY 000 ~ 255 000
C33 SLOT IDENTIFY 000 ~ 255 000
C34 LANDING ENABLE 000/001 000
C35 LANDING START 000/001 000
Item Contents Variable range Initial value
- - - LANDING CORRECTION -08 ~ 00 ~ +08 00