(No.MB409)1-9
3.1.10 Removing the main board
(See Fig.10 to 13)
(1) Remove the two screws J1. (See Fig.10)
(2) Disconnect the FFC cables J2 from the connector CN661
on main board. (See Fig.10)
(3) Disconnect the FFC cables J3 from the connector CN402
on main board. (See Fig.11)
(4) Disconnect the FFC cables J4 from the connector CN681
on main board. (See Fig.12)
(5) Remove main board from AMP board after disconnect the
connector J319
and CN601. (SeeFig.13)
Fig.10
Fig.11
Fig.12
Fig.13
J1 J1
J2
J3
J4
J4
To Next Page
Loading...
Need help?
General
