JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500 307
5.10 Expansion module MAC00-P4/P5
5.10.12 Cables for the MAC00-P4
The following cables equipped with connectors can be supplied by JVL.
Important: Please note that the cables are a standard type. They are not recommended for use in
cable chains or where the cable is repeatedly bent. If this is required, use a special robot
cable (2D or 3D cable).
MAC00-P4 Connectors
Description JVL Order no. Picture
“SLV
”
5pin
male
“CNT”
12pin
Fe-
male
“COM
”
5pin
Fe-
male
“PWR
”
5pin
Male
X
RS232 Interface cable. Con-
nects
directly from MAC00-P4 to a
PC
Length: 5m (197 inch)
RS232-M12-1-5-5
X
RS485 Interface cable. Con-
nects
directly from MAC00-P4 to a
PC with a RS485 Com. port.
Length: 5m (197 inch)
RS485-M12-1-5-5
X X
Cable (Ø5.5mm) with M12 fe-
male
5-pin connector loose wire
ends 0.35mm² (22AWG) and
foil screen.
Length: 5m (197 inch)
WI1000-M12F5T05N
X X
Same as above but 20m (787
inch)
WI1000-M12F5T20N
X
Cable with M12 male 12 pin
straight connector, loose wire
ends.
WI1009-M12M12T05N
X
Same as above but 20m (787
inch)
WI1009-M12M12T20N
X
RS485 Interface cable. Con-
nects directly from a master to
a slave motor via the SLV con-
nector. Length: 3m (197 inch)
WI1005-
M12F5TF5T03P
Protection caps. Optional if connector is not used to protect from dust / liquids.
X X
IP67 protection cap for M12
female connector.
WI1000-M12FCAP1
X X
IP67 protection cap for M12
male connector.
WI1000-M12MCAP1
To Next Page
Loading...