JVL MAC050 - Page 312

308 JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
5.10 Expansion module MAC00-P4/P5
5.10.13 Expansion MAC00-P5 connector description
The MAC00-P5 offers IP67 only IP65 on MAC400-800 protection and M12 connectors
which makes it ideal for process control and automation applications where no additional
protection is desired. The M12 and Harting connectors offer solid mechanical protection
and are easy to unplug compared to modules with cable glands or DSUB connectors.
The connector layout:
(Continued next page)
“CNT” - Control I/O. Harting 3HAN - 8pin male connector
Signal
name
Description
Pin
no.
JVL Ca-
ble
WI10xxx
xx
Isolation
group
AIN+ 4-20mA input. Positive terminal 1 Blue 2
AIN- 4-20mA input. Negative terminal 2 Red 2
AOUT+
4-20mA output. Positive terminal. Apply 7 to
24V to this terminal if internal AOUT supply is
disabled.
3 Grey 3
AOUT- 4-20mA output. Negative terminal. 4 Yellow 3
O+
Supply term. to the error output.
Apply 24VDC
5 Green 1
OUT1 Error output. PNP output. 6 Brown 1
P+ (CVI1)
Control supply input +18-32VDC. Consump-
tion typical 350mA @ 24VDC and 700mA
@24VDC if a slave motor is connected.
At MAC00-P5 the CVI1 is not present but
CVI1 is internally hard-wired to P+.
7 White 0
P- Main ground to be used with CVI1 and CVI2 8 Black (y) 0
* Note: Isolation group indicate which terminals/circuits that a galvanic connected to each other. In other
words group 1, 2, 3 and 4 are all fully independently isolated from each other. Group 0 correspond to the
housing of the motor which may also be connected to earth via the 115/230VAC power inlet.
Only MAC400-3000
Expansion module MAC00-P5 front plate
Slave connection (SLV)
M12 - 5pin male
connector includes:
- RS485 modbus
- 24VDC to slave
Communication (COM)
M12 - 5pin female
connector includes:
- RS232 interface
- RS485 Modbus (same as SLV)
Control I/O (CNT)
Harting 3HAN 8pin male
Contains
- 4-20mA input
- 4-20mA output
- Error output
- 24VDC supply input
TT1165GB