18
MOUNTING THE CONTROLLER FIELD WIRE ENTRANCES
The Pro-LC has a single keyhole slot on the top /
back of the controller. Two circular mounting holes
are located at the bottom / back of the controller.
Use a pencil to mark the eye level position on the
mounting wall. Or, use the template provided for
easy installation.
Drive an appropriate fastening device for the type
of wall material into the mark for the keyhole.
Hang the controller on the keyhole slot making sure
the fastener is secured on the narrow neck area of
the keyhole slot.
Making sure the controller is level, drive an
appropriate fastener(s) in the lower circular hole(s).
The Pro-LC controller has two plugs available
for the routing valve, pump start and sensor wires.
Both are located on the bottom of the cabinet
and sized to 1/2” and 3/4” PVC male adapters.
KEYHOLE SLOT
MOUNTING HOLES
PLUGS
To Next Page
Loading...
