10
C. PROGRAM THE UNLOCK TIME
Unlock time is the length of time the door will remain unlocked when a correct
code is entered before automatically re-locking itself.
Required User Level: Master, Manager
C-1 Put the lock into Pushbutton Programming Mode.
C-2 To establish Unlock Time, enter the following code: 004#TT#, where
TT is the time in seconds, (TT=02 to 20 seconds, for example 10 seconds).
C-3 Example of Complete Entry: 004#10#.
C-4 Enter another # to indicate the end of programming.
C-5 You have now programmed an Unlock Time of 10 seconds for the door.
D. PROGRAM THE DURATION OF
THE PASSAGE MODE PERIOD
You might want to program locks for public areas, such as cafeterias, to have
free access (Passage Mode) during certain periods of the day, and revert to
required code access outside of these regular hours.
The length of time that the lock remains in Passage Mode is programmable on all
models except EPS2000 PowerStar versions.
The factory default length of time for Passage Mode is 9 hours - you may leave
the default.
Once the lock has been put into Passage Mode, it will automatically relock after
the designated duration.
Required User Level: Master, Manager
D-1 Put the lock into Pushbutton Programming Mode.
D-2 Enter command code 005#.
D-3 Then TT#, where TT= 01 to 24 hours.
D-4 A TT entry of 00 means there is no time limit - the door remains
unlocked.
D-5 Enter 005 #TT#; for example, 005#06# for six hours.
D-6 Example of Complete Entry: 005#06#.
D-7 Enter another # to indicate the end of programming.
D-8 In this example, the lock will remain unlocked for six hours, starting from
the time you put it in Passage Mode.
D-9 You have now configured the duration of the Passage Mode period for
that lock. This does NOT
initiate Passage Mode.
D-10 The new length of time will take effect the next time you put a lock into
Passage Mode by following the correct command sequence.
To Next Page
Loading...
Need help?
General