19
O. ACTIVATE MANAGER ACCESS CODE
A Manager Code should be activated if it has been de-activated for a certain
time period - during a Manager’s vacation, for example, or if you created a
Manager’s Code, but never assigned it to anyone.
Required User Level: Master
O-1 Put the lock into Pushbutton Programming Mode.
O-2 Enter Command 301# to activate a Manager Access Code.
O-3 Enter the ID location NNN#, where NNN is the specific User ID location,
024 for example.
O-4 Example of Complete Entry: 301#024#.
O-5 Enter another # to indicate the end of programming.
O-6 The Manager Access Code will now work in that door with all the access
privileges assigned to a Manager User.
P. ACTIVATE SERVICE USER ACCESS CODE
A Service User Access Code should be activated if it has been de-activated for
a certain time period - during a Service User’s vacation, for example, or if you
created an Access Code but never assigned it to a Service User.
Required User Level: Master, Manager
P-1 Put the lock into Pushbutton Programming Mode.
P-2 Enter Command 302# for Service User Functional Code.
P-3 Enter the ID location NNN#, where NNN is the specific User ID location,
025 for example.
P-4 Example of Complete Entry: 302#025#.
P-5 Enter another # to indicate the end of programming.
P-6 You have now activated a Service User Access Code.
Q. ACTIVATE ALL USER ACCESS CODES
You may need to activate all users if you have de-activated the whole group -
after a lockout, for example. This procedure will re-activate all regular and
Service User Access Codes that are not active.
Required User Level: Master, Manager
Q-1 Put the lock into Pushbutton Programming Mode.
Q-2 Enter Command 398#.
Q-3 Example of Complete Entry: 398#.
Q-4 Enter another # to indicate the end of programming.
Q-5 You have now activated all regular User and Service User Access Codes.
To Next Page
Loading...
