21
Required User Level: Master
T-1 Put the lock into Pushbutton Programming Mode.
T-2 Enter Command 401# to de-activate a Manager Access Code.
T3 Enter the code 401#NNN#, where NNN is the specific Manager ID
location, 024 for example.
T-4 Example of complete entry: 401#024#.
T-5 Enter another # to indicate the end of programming.
T-6 You have now de-activated a Manager Access Code.
U. DE-ACTIVATE SERVICE USER ACCESS CODE
A Service User Access Code should be de-activated for a certain time period -
during a Service User’s absence, for example, or if you created an Access Code
but have not yet assigned it to a Service User. A Service User’s time period
continues to decrement if the User has only been de-activated, not deleted.
Required User Level: Master, Manager
U-1 Put the lock into Pushbutton Programming Mode.
U-2 Enter Command 402# to de-activate a Service User Access Code.
U-3 Enter the code 402#NNN#, where NNN is the specific Manager ID
location, 025 for example.
U-4 Example of Complete Entry: 402#025#.
U-5 Enter another # to indicate the end of programming.
U-6 You have now de-activated a Service User Access Code.
V. DE-ACTIVATE ALL ACCESS CODES
EXCEPT MASTER AND MANAGER
You may need to de-activate all users, for example, during a plant shutdown.
This procedure will de-activate all regular User Access Codes that are active,
excluding Master and Manager Codes.
Required User Level: Master, Manager
V-1 Put the lock into Pushbutton Programming Mode.
V-2 Enter Command 498# to de-activate all Access and Service Codes.
V-3 Example of Complete Entry: 498#.
V-4 Enter another # to indicate the end of programming.
V-5 You have now de-activated all regular User Access Codes.
To Next Page
Loading...
