17
J. DELETE USER ACCESS CODES
User Access Codes should be deleted if no longer needed. This frees the num-
bers to be assigned to another user. Codes that may be needed some time in
the future should be de-activated rather than deleted.
Required User Level: Master, Manager
J-1 Put the lock into Pushbutton Programming Mode.
J-2 Enter Command 200# to delete a User Access Code.
J-3 Enter the ID location NNN#, where NNN is the specific User ID location.
J-4 Example of complete entry: 200 #023#.
J-5 Enter another # to indicate the end of programming.
By deleting a User ID location, you have now also deleted a User Access Code,
allowing you to assign that number to another user if you wish.
K. DELETE MANAGER ACCESS CODES
A Manager Code should be deleted if no longer needed, in order to free the
code number to be assigned to another Manager User. Manager Codes that
might be needed some time in the future should be de-
activated rather than deleted.
Required User Level: Master
K-1 Put the lock into Pushbutton Programming Mode.
K-2 Enter Command 201# to delete a Manager Code.
K-3 Enter the ID location NNN#, where NNN is the specific Manager ID loca-
tion, 024 for example.
K-4 Example of complete entry: 201#024#.
K-5 Enter another # to indicate the end of programming.
You have now deleted a Manager ID location, and (indirectly) his Access Code,
allowing you to assign that number to another Manager or Access User if you
wish.
L. DELETE SERVICE USER ACCESS CODES
A Service User Access Code is automatically deleted at the end of its specified
length of time. However, use this procedure if you want to delete the code ear-
lier than the specified expiry time.
Required User Level: Master, Manager
L-1 Put the lock into Pushbutton Programming Mode.
L-2 Enter Command 202# to delete Service User Access Code.
L-3 Enter the ID location NNN#, where NNN is the specific Service User ID
location, 025 for example
To Next Page
Loading...
Need help?
General