20 IV User Manual Pedelec with ont motor
› Undo the two hexagon socket screws on the le
behind the fork using a 5 mm Allen key. You need
to turn them anticlockwise.
Apply a max. tightening torque of 9.5Nm to these
screws when putting the wheel back on
1 + 2 Hexagon socket screws on the fork
1
2
› You can now start removing the ont wheel.
› Once you have put the ont wheel back on, repeat
these steps in reverse. This ensures that your Pe-
delec will work properly.
For a detailed description on how to remove and install
the ont wheel, refer to the General User Manual.
The General User Manual also contains all other bicycle-
related information on your Pedelec.
10 Cleaning
Remove the battery before you clean your Pedelec.
We recommend you clean your Pedelec with a damp cloth,
a sponge or a brush. You can obtain suitable cleaning
agents and additional information om your specialist
cycle shop.
Make sure when cleaning that water does not enter the
battery. Although the electrical components are sealed,
it is not advisable to clean the bike by spraying it with a
hose or a high-pressure cleaner. This could damage your
bike.
When wiping down the battery, be carel not to touch and
connect the contacts on the underside. This could cause
the battery to switch o.
To Next Page
Loading...
