Kalkhoff Suomi - Battery Information System; Checking the Battery Capacity; Checking the Battery Charge State

28 V User Manual Impulse Pedelec
7.4.1 Checking the battery charge state
Press the Push button briey; the LEDs light up and dis-
play the current battery charge state.
DISPLAY BATTERY CHARGE STATE
•••••
5 LEDs light up 100 – %
••••
4 LEDs light up  – %
•••
3 LEDs light up  – %
••
2 LEDs light up  – %
•
1 LED lights up  – %
¡
1 LED ashes  – %
5 LEDs ash quickly % or overloaded *
1. LED ashes quickly Charging fault **
* All 5 LEDs ash quickly: The battery is empty and is
being switched o, or is overloaded.
› If the battery is overloaded, it will switch back
on aer a short idle period and can then be used
normally.
› If the battery is empty, it will work once again
briey following a short period of rejuvenation and
will then switch back o. It must now be charged.
** The 1st LED ashes quickly: A charging fault is present.
› If this occurs, put the battery in the docking station
for a short period of time or insert the plug of the
charger into the battery. The charger performs a
readjustment. If the LED still ashes, take the
battery to your specialist cycle shop and have it
checked.
7.4.2 Checking the battery capacity
If you press the “Push” button for ve seconds, the LEDs
show the current capacity of the battery.
DISPLAY CAPACITY
•••••
5 LEDs light up  – %
••••
4 LEDs light up  – %
•••
3 LEDs light up  – %
••
2 LEDs light up  – %
•
1 LED lights up  – %
¡
1 LED ashes  %
7.4 Battery information system
There is a display panel on the outer face of the battery
which includes ve LEDs and a button with an LED (Push).
When you press the Push button, the LEDs light up. Infor-
mation about the battery and its charge state is provided
based on the number of LEDs that light up and the way in
which they light up.
Charge state and battery capacity indicator