30 V User Manual Impulse Pedelec
› If a charging fault occurs, the LED in the charger
ashes red. In this case, the charging current is too
high.
› Take the battery out of the charger, then put it back
in again.
› If the error message appears again, the battery and
charger must be checked by a specialist dealer.
If used incorrectly, the device may be damaged or
inict injuries.
› Before cleaning the charger, always pull the plug
out of the socket to avoid a short-circuit and/or
physical injury.
› Only use the charger in dry rooms.
› Only place the charger in a secure stable position
on a suitable surface.
› Do not cover the charger or place any objects on
it as otherwise it could overheat and catch re.
8 Charger
Read the two type plates on the charger before using it for
the rst time.
You can charge your Pedelec with Impulse drive directly
via a charging socket in the battery. The battery can
remain on the Pedelec when the charging operation is in
progress.
You can also take the battery out of the holder and charge
it in the docking station. This is recommended if it is cold
outside, in order to charge the battery in a warm room.
Battery in the docking station
Do not use other chargers. Only charge the battery
using the charger provided, or a charger approved
by us.
To Next Page
Loading...
