Kalkhoff Suomi - LCD Control Panel with Display

18 V User Manual Impulse Pedelec
5.2 LCD control panel with display
LCD control panel
1 Power
2 More powerl assistance
3 Less powerl assistance
4 Set
5 Pushing assistance
1
3
5
4
2
•
1
The “Power” button is located on the right-
hand side. Press once to switch the system on and
press a second time to switch it o.
•
2 3
The arrow buttons used to control the
level of assistance are located on the le-hand side
of the control panel.
•
4
The “Set” button is located between the arrow
buttons. Using this button, dierent displays can
be called up. Program the system with your desired
data.
•
5
If the model features pushing assistance, the
switch for this will be on the underside of the
control panel.
LCD display
1 Speed
2 Power-assist mode
3 Battery charge state
4 Remaining distance display
5 Information area
1
5
4
2
3
The LCD display in the middle of the handlebar is divided
into ve dierent display panels.
•
1
At the top on the le is your current speed.
•
2
Next to current speed on the right is a display
showing the selected power-assist mode.
•
3
At the top on the right is the battery symbol
which tells you the current charge state of your
Pedelec’s battery.
•
4
Below this, you can see the remaining distance
over which you will still receive assistance om
the current battery charge.
•
5
Along the bottom section of the display is a
long information area that can be used to display
the following information:
• How much of its potential output the motor is
currently delivering.
• The costs that have been incurred in the course
of the current trip and during the Pedelec’s
entire service life.
• The savings achieved in both euros and CO
2
in
comparison with the same journey by car.
• The total number of kilometres covered by this
system.
• Display of kilometres covered during the day
and overall.