V User Manual Impulse Pedelec 17
1
2
1 Spoke magnet
2 Sensor on chain stay
Only for bikes which are equipped with a back-pedal brake:
If the le-hand LED begins to ash with a long ash, fol-
lowed by short ashes om all LEDs, this means that you
have still to carry out the safety test for the “drive” or
“back-pedal brake” pedal positions or that the positions
were not recognised correctly.
› In this case, move the pedals forward once and
then back once, until you can feel some resistance.
If the ashing signal disappears you can ride o
normally. If the ashing signal continues, you can
ride as if you were riding a bike without power
assist. Have a specialist dealer check your error
message and recti the problem.
Have the electric drive inspected regularly by your
specialist cycle shop. Do not carry out any work on
the electric drive or battery yourself. Unless you have
sucient expertise this could lead to a serious
accident. As a basic rule, always consult your special-
ist cycle shop if you have a problem with the electric
drive or the battery.
You should only have the electrical components of
your Pedelec replaced with genuine parts. This makes
it safer for you and avoids problems when processing
warranty claims.
To Next Page
Loading...
