To Next PageTo Next Page
Need help?Do you have a question about the Kannad 406 AF-COMPACT and is the answer not in the manual?
General| Waterproof Rating | IP67 |
|---|---|
| Operating Temperature | -20°C to +55°C |
| Category | Emergency Locator Transmitter (ELT) |
| Frequency | 406 MHz |
| Activation | Manual and automatic |
| Compliance | COSPAS-SARSAT |
| Battery Life | Minimum 24 hours |
Details the COSPAS-SARSAT system's purpose and global coverage.
Lists environmental tests and certifications for ELTs.
Explains G-Switch function and importance in crash detection.
Identifies the individual components of the KANNAD 406 AF-COMPACT ELT pack.
Describes the KANNAD 406 AF-COMPACT transmitter, its features, and housing.
Details the mounting bracket and its function for securing the ELT.
Explains the RC200 remote control panel for monitoring and controlling the ELT.
Describes the available whip and rod antennas for the ELT system.
Explains transmitter operation, transmission frequencies, and modulation.
Details controls, indicators, and connectors on the ELT front panel.
Describes the four operating modes: Off, Self-Test, Armed, and On.
Information on operational duration and battery requirements.
Lists transmitter characteristics and electrical interface details.
Summarizes key technical specs, environmental conditions, and qualifications.
Overview of RC200 purpose, cockpit installation, controls, and connector.
Explains RC200 remote control and monitoring functions.
Details RC200 mechanical and electrical specifications.
Describes RC200 connections, pin-out, and environmental specifications.
Technical specifications for the ANT200 whip antenna.
Technical specifications for the ANT300 rod antenna.
Notes any limitations regarding equipment use.
Explains standby and manual activation modes.
Describes manual and remote control panel reset methods.
Directs to the self-test procedure for checking functionality.
Details mandatory ELT registration in USA and Canada.
Explains ELT programming options and required equipment.
Recommendations and requirements for ELT and bracket installation.
Covers antenna installation recommendations and steps.
Details RC200 installation recommendations and steps.
Describes ELT connection and initial power-up tests.
Outlines steps for safely removing the ELT.
Explains self-test periodicity and detailed procedure.
Details operational tests for ELT and RC200 indicators/buzzers.
Describes how to perform 406 MHz and 121.5 MHz transmission tests.
Explains using the ELT indicator light for fault diagnosis.
Details specific fault conditions indicated by flash codes during self-test.
Provides dimensional drawings for the ELT unit.
Shows the drilling mask for mounting the ELT.
Displays dimensional drawings for the RC200 panel.
Provides the drilling mask for RC200 installation.
Shows dimensions for ANT200 and ANT300 antennas.
Illustrates wiring connections between ELT, RC200, and antenna.
Outlines periodic inspection and battery replacement requirements.
Details steps for performing periodic inspections and checks.
Specifies mandatory inspections and tests every six years.
Provides instructions and requirements for replacing the ELT battery pack.
