kansai MAC100 - 2 Machine Speed; Machine Speed & Direction in Which the Machine Pulley Runs; Motor & Belt

2
Ｍ
ＭＭ
Ｍ
Ｍ
ＭＭ
Ｍ
Ａ
ＡＡ
Ａ
Ａ
ＡＡ
Ａ
Ｃ
ＣＣ
Ｃ
Ｃ
ＣＣ
Ｃ
1
11
1
1
11
1
0
00
0
0
00
0
0
00
0
0
00
0
【
2
】
MACHINE SPEED
2
22
2-
--
-1 Machine speed & direction in which the machine pulley runs
1 Machine speed & direction in which the machine pulley runs1 Machine speed & direction in which the machine pulley runs
1 Machine speed & direction in which the machine pulley runs
Maximum speed : 2,500 rpm
Standard speed : 2,000 rpm
To extend machine life, run the machine
approximately 15~20% below the maximum speed
for the first 200 hours of operation (approx. 1
month).
Then run the machine at the standard speed.
The machine pulley turns counterclockwise as seen
from the end of the machine pulley (see the
illustration).
2
22
2-
--
-2 Motor & belt
2 Motor & belt2 Motor & belt
2 Motor & belt
Motor : 3-phase, 2-pole, 400W clutch motor
Belt : M type V belt
Select the proper motor pulley according to the
machine speed (refer to the motor pulley outer
diameter on the table below). Adjust the position of
the motor by pressing the finger onto the middle of
the belt so that 1~2cm deflection can be achieved
(see the illustration).
< Motor pulley selection table >
Machine speed (SPM) Motor pulley
outer diameter
(mm)
50Hz 60Hz
40 1650 1950
50 2050 2450
60 2500 2950
70 2900 3450