kansai MAC100 - Looper and Needle Timing; Needle Height Adjustment

5
Ｍ
ＭＭ
Ｍ
Ｍ
ＭＭ
Ｍ
Ａ
ＡＡ
Ａ
Ａ
ＡＡ
Ａ
Ｃ
ＣＣ
Ｃ
Ｃ
ＣＣ
Ｃ
1
11
1
1
11
1
0
00
0
0
00
0
0
00
0
0
00
0
4
44
4-
--
-2
2 2
2 To instal
To instalTo instal
To install the machine
l the machinel the machine
l the machine
Install the brackets on the underside of the table board (see the illustration below).
Fit the rubber cushions onto the brackets.
Mount the machine head on the rubber cushions correctly.
【
5
】
TIMING OF THE LOOPER TO THE NEEDLE
5
55
5-
--
-1
1 1
1 Nee
NeeNee
Needle height
dle heightdle height
dle height
When the needle bar is at the top of its stroke
(needle position 2~3), there should be a distance of
approximately 9~9.5mm from the top surface of the
needle plate to the point of the needle.
Adjustment is made by loosening screws A.
< Note >
After the above adjustment is made, check to make
sure each needle drops correctly into the center of
each needle drop hole.