CAN RANGER OPERATION
13
the actuator’s ZERO
position may not be
correct. If you get
strange/incorrect position
readings, this may be the
reason.
ACTUATOR CALIBRATION
The receiver is programmed
for default values for each
actuator at the factory.
Please refer to Appendix B for
factory setting values.
PLEASE NOTE: IF THE
FOLLOWING PROCEDURE IS
NOT PERFORMED PRIOR TO
OPERATION, THE ENGINE STOP
MAY BE ON CONTINUOUSLY!
ACTUATOR CALIBRATION
USING THE MANUAL
HANDLES
Using the buttons on the CAN
Ranger Receiver, navigate
through the LCD screens to
CALIBRATION. Press <SET>.
Use the arrow buttons to
enter the password 1262.
Enter the password by
pressing <SET>. Then press
the right button (FWD arrow)
to get to:
ACTUATOR SETUP
PUSH SET
Next presses the right button
(FWD arrow) to get to the
actuator you want to
calibrate.
During the calibration you will
be asked to calibrate center,
fast, slow, and engine stop
positions. These positions are
defined as follow:
CENTER POSITION
This is the position the
actuator moves to when the
transmitter is ON and the
joystick is in neutral (center
position). This position is
normally the valve handle in
To Next Page
Loading...