CAN RANGER OPERATION
5
continue to center the
valve/handle.
TRANSMITTER AND
RECEIVER
SYNCHRONIZATION
Each radio transmitter is
preprogrammed with a unique
radio ID code. Each receiver is
programmed to respond only
to the radio transmitter with
the ID code for which it is set.
This feature allows multiple
systems to work in close
proximity to one another
without interference. In the
event that a transmitter
becomes damaged and a new
one is needed, the receiver
can be reprogrammed to
respond to the new radio
transmitter. To teach the ID
code to the receiver, use the
following procedure:
1. Receiver and
transmitter power
should be off
2. Press E-STOP switch,
position BOOM toggle
switch to NORMAL,
WINCH switch to FAST,
and BASKET LEVELING
to AUTO
3. Press and hold HORN
button (on side) and all
joysticks down (pull
joysticks)
4. Turn transmitter
POWER on.
5. Release joysticks, Twist
to release the E-Stop
switch. At this point
LEDs on transmitter
should toggle.
6. Apply power to receiver
To Next Page
Loading...
