CAN RANGER OPERATION
6
7.
LEDs on transmitter will
stop toggling and the
green LED will blink
rapidly to indicate that
the teach is complete
INDICATORS
The transmitter has four
indicators. The red
BATTERY/DIAGNOSTIC
indicator, the green
TRANSMIT indicator on top,
and the red and green battery
charger indicators on the side
next to the connector. The
green TRANSMIT indicator
flashes rapidly whenever
there is communication
between the transmitter and
the receiver. The red
BATTERY indicator starts
blinking once every second
when the battery voltage is
low and requires charging.
If the ATB Input is enabled
in calibration and the ATB
input is driven high (12/24V),
the red and green LEDs on
the transmitter will Flash
Alternately while using a
joystick.
If the OVERLOAD Input is
enabled in calibration and the
input is driven high (12/24V),
the red and green LEDs on
the transmitter will flash
together while using a
joystick.
If the Automatic Tilt feature
has been enabled, the
optional basket angle sensor
needs to be attached to the
transmitter’s charging/CAN
connector. Then the Tilt
Switch should be placed in the
AUTO position to operate.
Switching to Manual mode
disables the feature. To tare
To Next Page
Loading...
