CAN RANGER OPERATION
3
The receiver has an RS-232
communication port to
interface with an optional
Palm Pilot diagnostic tool.
The CAN RANGER system
drives and controls the
position of the actuators with
respect to the position of the
transmitter joysticks. The
actuators in turn control the
appropriate valves.
The receiver will automatically
detect the system voltage and
adjust for either 12V or 24V
vehicles.
SYSTEM OPERATION
In the wiring harness, there
are two switches for REMOTE
POWER. They provide power
to the CAN Ranger Receiver if
both are ON. Turning either
switches OFF will power down
the CAN Ranger, and the CAN
Actuators.
To turn on the transmitter,
turn the key switch to the ON
position. To turn it off, turn
the key switch to the OFF
position.
The E-STOP button on the
transmitter must be up to
start engine and operate any
functions. To operate the
boom and winch, press
ENABLE and HORN for at least
1 second. After 1 second, you
can release HORN and use
ENABLE when you want to
operate a function. If the
ENABLE is not used for longer
than 1 minute, you must start
again with both ENABLE and
HORN as before.
To Next Page
Loading...
