CAN RANGER OPERATION
22
switch is in the SLOW
position. The step size is
larger when the SPEED switch
is in the FAST position. If not
using the transmitter to
calibrate the RPM Actuator,
just physically move the
actuator into the Idle and Max
RPM positions when
instructed.
After going through the
selected setup screens, you
have the choice to save or to
quit without saving:
PUSH SET TO SAVE
PUSH ← TO QUIT
Note: If you return to the
same RPM type that is
currently saved, the
parameters will be as they are
currently set. If you change
from one type of RMP to
another, the parameters will
revert to the default settings.
To Next Page
Loading...
