Kasanova E-mootika - Installation of Steering Handle

68
E-MOOTIKA
INSTRUCTION MANUAL
ENG
1- Across handle Stems
2- Top cover of Vertical handle
stems
3- Top cover bolt of Vertical handle
stems
4- 4mm hexagon spanner
3.4. Installation of steering handle
3.4.1 Installation of Mountain bike steering handle
1- Take out the Across handle Stems, remove the protective paper
above the Across handle Stems, and spin off four xed screws on
the Vertical handle stems;
2- Remove the top cover of the Vertical handle stems, x the Across
handle Stems to the Vertical handle stems, and adjust the angle of
the Across handle Stems;
3- Tighten the top cover of the Vertical handle stems with the bolt
by 6N.m torque to ensure that the up and down gap of the top
cover of the stand pipe is even.