76
E-MOOTIKA
INSTRUCTION MANUAL
ENG
by toes or legs can not stretch slightly, fatigue and sports
injury will be caused, so there is a careful need for adjustment of
the height of the Seat post.
The Seat post has a MAX marked line (that is, the safety line), and
the so-called insertion mark can not be higher than the seat
connector. In case of improper use, serious injury may be caused to
the rider.
Seat angle: in order to avoid leaning forward when riding, it is
appropriate for the front end of the seat to lean upward, the front
and rear position can be appropriately adjusted based on individual
height and the seat bar is generally in the middle.
Minimum height of the seat: move the quick release handle to the
OPEN position, then put the Seat post to the lowest place, and
when the Seat post can not enter into the seat tube of the frame, it
is the minimum height of the seat;
Maximum height of the seat: move the quick release handle to the
OPEN position, then lift the Seat post to the top but the safety line
is not exposed, when it is the maximum height of the seat.
Measurement method: place the bike perpendicular to the ground,
and the distance from the highest part of the curved surface of the
seat vertical to the ground is the height of the saddle.
4.6 Braking system
The braking system is an accessory necessary for each bike and is
the key to trafc safety; before driving, you must understand your
braking system, and do a good job in the inspection and adjustment
work.
The general idea is that upon hard braking, the bike will surely
stop in a short distance, but that is wrong. Upon hard braking,
when the wheels are suddenly jammed by the brake rubber, the bike
will glide horizontally, and it not only is dangerous but the
braking distance will be lengthened. Therefore, the concept should
be established is that the braking system is only used to adjust the
speed of the bike.
To Next Page
Loading...