89
E-MOOTIKA
INSTRUCTION MANUAL
ENG
S/N FAILURE CAUSE ELIMINATING METHODS
1
Failed speed change
or too low maximum velocity
1- Low battery voltage
2- Bad governor handle
3- Bad controller
1- Charge the battery fully
2- Replace the governor
handle, controller
2
Turn on the power supply,
but the motor does not work
1- Bad governor handle
2- Bad electric door lock and
contact point
3- Bad controller
1- Replace the governor
handle, controller
2- Re-weld the contact part
3
Inadequate mileage of one-time
charging continuation line
1- Tire lacks of air pressure
2- Inadequate charging or failed
charger
3- The battery has been damaged
or its life has expired
4- Frequent braking startup,
overloading
1- Tire is full of air
2- The battery is adequate or
replace the charger
3- Replace the battery
4 The charger is not charged
1- The charger wiring is loose or
damaged
2- The battery weld line falls off or
is damaged
1- Weld the connecting line
or replace
2- Weld the connecting line
or replace
5
The booster has no
power assisting
1- The induced cartridge has poor
contact or is damaged
2- The booster wiring is bad or
damaged
1- Adjust the induced cartridge
or replace
2- Re-connect or replace
To Next Page
Loading...