KDK 30BGCH - How to Use Drying Function

21
乾燥功能的使用方法
HOW TO USE DRYING FUNCTION
使用乾燥功能進行衣物烘乾時，建議按照下圖進行安裝:
To use the drying function to dry clothes, please to install the product as shown below:
Unit: mm
單位：mm
為使乾 衣效果更 好，建議 在門下部設置有效開口
面積應 在100 cm²以上的換 氣用百葉 窗。
Clothes hanging
pipe(Need to be
purchased)
掛衣 用管(另 購)
To make the effect of drying clothes better,
please set a ventilation shutter at the lower
part of the door with a valid opening area of
100 cm² or above.
Use when you need to dry the bathroom or clothes
(Initial settings)
In the DRY HOT mode running for 30 seconds above, press the
button to stop the heater. The fan will stop running after a delay
of 20 seconds.
1
2
3
4
5
This product will stop automatically when the set time is up.
To stop midway in running, press the button.
Press the button to start the DRY HOT mode. It will switch to
the DRY COOL mode if you press this button again.
To confirm the current running mode and remaining time for
reference, press the button.
乾燥浴室或乾衣物時使用
按 按鈕，熱乾燥模式開始運轉，再按一次將切換為涼乾燥模式。
若在熱乾燥模式運轉30秒以上，按 按鈕後，為使加熱器冷卻，扇葉將
延時20秒停止運轉。
如需確認當前運轉模式及參考剩餘時間請按 按鈕。
如需在運轉途中停止，請按 按鈕。
運轉完所設置時間後，本機會自動停止。
熱乾 燥
(初始 設置)
涼乾 燥
During running, you can press to change the running time.
運轉過程中，可通過 按鈕，調整運轉時間。
The indicators of COOL or HOT and default setting time (15 MIN.)
light on, then turn off automatically after 3 seconds.
COOL或HOT的指示燈和初始設置時間(15 MIN.)的指示燈亮，3秒鐘後
指示燈自動熄滅。