KEB COMBIVERT S6 Series

3.3 Mounting instructions for control cabinet installation
For mounting the drive controllers, the following fastening materials with the correspond-
ing quality were tested by KEB.
Required material Tightening torque
Screw assembly ISO 7045 - M6 - 8.8
3.2 Nm
29 lb inch
Table 8: Mounting instructions for control cabinet installation
NOTICE
Use of other fastening material
► The alternatively selected fastening material must comply with the
above-mentioned material characteristics (quality) and tightening
torques !
TheuseofotherxingmaterialsisbeyondKEB'scontrolandisthere-
fore the sole responsibility of the customer.
32
MOUNTING INSTRUCTIONS FOR CONTROL CABINET INSTALLATION