Keba KeContact P30 - UDP Command: Start

P30 UDP commands
UDP Programmers Guide V2.01
25
© KEBA
Command structure
Command Parameters Additional Description
output [n]
0 Close
1 Open
>= 10
Pulse output with the specified number of
pulses (pulses / kWh) and is stored in the
EEPROM; reasonably usable up to 150.
Reply structure
Field Contents Additional Description
- TCH-OK: done Generic confirmation message
3.2.9 UDP command: start
The command start can be used to authorize a charging session if the au-
thorization function is activated. The effect is the same as holding an RFID
card in front of the RFID reader. The command needs a valid RFID tag from
the whitelist of the charging station. The token (tag) and the classifier are
hexadecimal strings as in report 100.
Command structure
Command Parameters Additional Description
start [id]
[class]
[id]: RFID tag 8 byte hex string, identifier of RFID card
[class]: RFID class 10 byte hex string, classifier of RFID card
Reply structure
Field Contents Additional Description
- TCH-OK: done Generic confirmation message