Keba KeContact P30 - Default Chapter; Table of Contents

P30 Table of contents
UDP Programmers Guide V2.01
5
© KEBA
Table of contents
1 Introduction ................................................................................................................
7
1.1 Safety instructions............................................................................................
7
1.1.1 Representation of safety instructions.................................................
8
1.2 Verification of validity .......................................................................................
8
1.3 Target group ....................................................................................................
8
1.4 Requirements...................................................................................................
9
1.5 Further documentation and software ...............................................................
9
2 UDP interface: Guidelines .........................................................................................
10
2.1 Required command delays ..............................................................................
10
2.2 Addressing and communication port................................................................
10
2.3 Recommended communication buildup scheme .............................................
11
2.4 RFID authorization ...........................................................................................
11
2.4.1 P30 c-series.......................................................................................
11
2.4.2 P30 x-series.......................................................................................
12
2.5 Current control .................................................................................................
13
3 UDP commands..........................................................................................................
14
3.1 General information .........................................................................................
14
3.2 UDP commands intended for regular use........................................................
15
3.2.1 UDP command: i................................................................................
15
3.2.2 UDP command: report 1 ....................................................................
15
3.2.3 UDP command: report 2 ....................................................................
16
3.2.4 UDP command: report 3 ....................................................................
18
3.2.5 UDP command: report 1xx (historical log entries) .............................
19
3.2.6 UDP command: currtime ...................................................................
21
3.2.7 UDP command: setenergy.................................................................
24
3.2.8 UDP command: output ......................................................................
24
3.2.9 UDP command: start .........................................................................
25
3.2.10 UDP command: stop..........................................................................
26
3.2.11 UDP command: setdatetime..............................................................
28
3.2.12 UDP command: display .....................................................................
30
3.2.13 UDP command: unlock ......................................................................
30
3.3 UDP commands with permanent effects..........................................................
31
3.3.1 UDP command: ena ..........................................................................
31
3.3.2 UDP command: curr ..........................................................................
32
3.3.3 UDP command: failsafe .....................................................................
34
3.4 UDP status messages .....................................................................................
35