P30UDP commands
UDP Programmers Guide V2.01
26
© KEBA
Example
● Authorization is set to "ON"
● Charging station and vehicle are ready to start the charging session
3.2.10 UDP command: stop
The command stop can be used to deauthorize a charging session if the au-
thorization function is activated. The effect is the same as holding an RFID
card in front of the RFID reader during a running charging session. The
deauthorization will only work correctly if the RFID tag used is the same as
the one used to start the charging session.
Command structure
Command Parameters Additional Description
stop [id]
[id]: RFID tag 8 byte hex string, identifier of RFID card
To Next Page
Loading...
