P30 Introduction
UDP Programmers Guide V2.01
9
© KEBA
1.4 Requirements
The following requirements have to be met in order to use the UDP function-
ality:
● KeContact P30 c-series or x-series
with firmware version 3.9.14 or higher
● The UDP interface is enabled by switching the DIP switch DSW1.3 to
“ON” (for details regarding the DIP switches, see the "installation man-
ual").
● A PC or smartphone for sending the UDP commands.
This also requires a suitable UDP client software or UDP app.
● The charging station has to be connected (via LAN cable or WLAN) to
the same network as the application.
Information
The latest manuals and firmware can be downloaded here:
www.keba.com/en/emobility/service-support/downloads/Downloads
1.5 Further documentation and software
Manuals, further information and software downloads are available on the
KEBA website:
www.keba.com/en/emobility/service-support/downloads/Downloads
To Next Page
Loading...
