QuNeo ediTor
21
QuNeo
numerical value in the number box will override the default behavior and output just that value.
The Global Sensitivity dial adjusts the sensitivity of the sensors. The higher the sensitivity, the easier it
is to get pressure and velocity in the higher value ranges. The lower the sensitivity, the more difcult (or
impossible) it will be to get the pressure and velocity to the higher value ranges. The Sensitivity dial is
global for all controls of that sensor type. For example, if you adjust the global sensitivity of one Pad you are
adjusting the sensitivity of all Pads, however it will not affect the sensitivity of the sliders.
The Long Slider Basic Edit tab also has a number box to set the CC# for Width (a value representing the
distance between two ngers held down on the Long Slider.)
sliders - advaNCed Tab
The On Thresh sets the pressure value at which a Note On message is
sent. Example: If set to 10, the Slider pressure has to reach a value of
10 before a note on is sent. This is global for all Sliders.
The Off Thresh sets the pressure value at which a Note Off message
is sent. Example: If set to 5, the Slider pressure would have to be 5 or
lower for a Note Off to register. This cannot be set higher than the On
Threshold. This is global for all Sliders.
sliders - leds Tab
The LEDs tab is where you set which MIDI Channel the Slider LEDs will
listen to for Remote LED Control. This parameter is global per sensor
type, so if editing the LED channel in a Horizontal Slider edit pane, all
of the Horizontal Sliders will change to the same channel. For more
information see Section 2.6.2 Remote LED Control. Uncheck the box
marked “Local LED Control” to disable Local LED behavior.
To Next Page
Loading...
Need help?
General