appeNdiCes
29
QuNeo
appeNdix a: QuNeo 2.0 faCTory preseTs:
Notes about the Preset Guide images:
If a data source is not accounted for in the preset guide image, this means it is disabled. For Example: If one of the
Pads only shows note names and not pressure CC#s, assume that the pressure data is turned off and will not output
as MIDI data, even in CoMA mode.
Assume that all notes and pressure sources use Normal mode (as opposed to Toggle mode) unless otherwise
indicated in the preset descriptions below.
MIDI Output
Preset 1: (Drum C1-D#2 / Serato)
Preset 2: (Drum E2-G3)
Preset 3: (Drum G#3-B4)
Preset 4: (Drum C5-D#6)
Presets 1-4 are the same except the pad notes increment up as the preset # increases. So the pad notes on preset 1
are shown below from C1-D#2, preset 2 are from E2-G3, preset 3 are from G#3-B4, and preset 4 are from C5-D#6.
These presets are in Drum Mode and don’t use banks. Rotaries are set to use Direction instead of Location. Pass Thru
Widths for the rotaries are set to 127. The Pad X/Y Return values are set to 63. Velocity is variable and pressure is
continuous on the Pads; velocity is xed at 127 for notes on other sensors.
Our Serato Template uses Presets 1-3 and is included in the QuNeo Software Installer.
Scratch Live (Serato) Mappings for Preset 1, 2, & 3:
Global:
1. LOAD Deck 1 - loads the selected track from the main track library or crate to Deck 1
2. LOAD Deck 2 - loads the selected track from the main track library or crate to Deck 2
3. Track Library Browse - Browse Up and Down a crate or the main Track Library.
To Next Page
Loading...
Need help?
General