Keithley 2000 - Table 1-2 Table

2000-903-01 Rev. C / October 2007 Return to Section Topics 1-7
Model 2000 Digital Multimeter Quick Start Guide Section 1: Introduction
STEP key — Pressing this key starts a stepping operation of consecutive channels, where output
triggers are sent after every channel closure.
SCAN key — Pressing this key starts a scanning operation of consecutive channels, where an
output trigger is sent at the end of the scan list.
HALT — Pressing SHIFT and then HALT stops stepping or scanning.
Factory default conditions
Table 1-2
Factory defaults
Setting Factory default
Autozero
Buffer
Continuity
Beeper
Digits
Rate
Threshold
Current (AC and DC)
Digits (AC)
Digits (DC)
Filter
Count
Mode
Range
Relative
Value
Rate (AC)
Rate (DC)
Diode test
Digits
Range
Rate
Frequency and Period
Digits
Range
Relative
Value
Rate
Function
GPIB
Address
Language
Limits
Beeper
High limit
Low limit
mX+b
Scale factor
Offset
Percent
References
On
No effect
On
4
Fast (0.1 PLC)
10¾
5
6
On
10
Moving average
Auto
Off
0.0
Medium*
Medium (1 PLC)
6
1mA
Medium (1 PLC)
6
10V
Off
0.0
Slow (1 sec)
DCV
No effect
(16 at factory)
(SCPI at factory)
Off
Never
+1
-1
Off
1.0
0.0
Off
1.0