Keithley 2000 - Page 32

2000-903-01 Rev. C / October 2007 Return to Section Topics 1-21
Model 2000 Digital Multimeter Quick Start Guide Section 1: Introduction
:CURRent:AC
:NPLCycles <n>
:NPLCycles?
:RANGe
[:UPPer] <n>
[:UPPer]?
:AUTO <b>
:AUTO?
:REFerence <n>
:STATe <b>
:STATe?
:ACQuire
:REFerence?
:DIGits <n>
:DIGits?
:AVERage
:TCONtrol <name>
:TCONtrol?
:COUNt <n>
:COUNt?
:STATe <b>
:STATe?
Path to configure AC current.
Set integration rate (line
cycles; 0.01 to 10).
Query line cycle integration
rate.
Path to configure
measurement range:
Select range (0 to 3.1).
Query range.
Enable or disable auto range.
Query auto range.
Specify reference (-3.1 to
3.1).
Enable or disable reference.
Query state of reference.
Use input signal as
reference.
Query reference value.
Specify measurement
resolution (4 to 7).
Query resolution.
Path to configure and control
the filter.
Select filter type: (MOVing or
REPeat).
Query filter type.
Specify filter count (1 to 100).
Query filter count.
Enable or disable filter.
Query state of digital filter.
:CURRent:AC
:DETector
:BANDwidth <NRf>
:BANDwidth?
Path to configure bandwidth:
Specify bandwidth (3 to
300e3).
Query bandwidth.
Table 1-10
SENSe command summary (cont.)
Command Description