1-30 Return to Section Topics 2000-903-01 Rev. C / October 2007
Section 1: Introduction Model 2000 Digital Multimeter Quick Start Guide
Table 1-14
Trigger command summary
Command Description
:INITiate
[:IMMediate]
:CONTinuous <b>
:CONTinuous?
:ABORt
:TRIGger[:SEQuen
ce[1]]
:COUNt <n>
:COUNt?
:DELay <n>
:AUTO <b>
:AUTO?
:DELay?
:SOURce
<name>
:SOURce?
:TIMer <n>
:TIMer?
:SIGNal
:SAMPle
:COUNt <NRf>
:COUNt?
Subsystem command path:
Initiate one trigger cycle.
Enable or disable continuous
initiation.
Query continuous initiation.
Reset trigger system.
Path to program Trigger
Layer:
Set measure count (1 to
9999, or INF).
Query measure count.
Set delay (0 to 999999.999
sec)
Enable or disable auto delay.
Query state of delay.
Query delay.
Select control source
(IMMediate, TIMer, MANual,
BUS, or EXTernal).
Query control source.
Set timer interval (0 to
999999.999 sec).
Request the programmed
timer interval.
Loop around control source.
Specify sample count (1 to
1024).
Query sample count.
To Next Page
Loading...
