CONTROL PANEL OPERATIONS3.
MXF wire feeders can be connected to either Fastmig Pulse or Fastmig Synergic power
sources.
PF65 function panel is compatible with Fastmig Pulse and SF53 and SF54 panels enable
compatibility with Fastmig Synergic KMS power sources.
CONNECTING AND MOUNTING3.1
1.
Fasten the ribbon cable connector from the MXF wire feed unit to the function panel.1.
2.
Place the bottom edge of the panel behind the securing clips on the machine. Remove 2.
the xing pin from the top edge with, for example, a screwdriver. Then gently push
the upper part of the panel into place. Make sure that the cables do not get damaged,
continue gently pushing the upper part of the panel until it clips into place.
14
FastMig MXF65, 67 / © Kemppi Oy / 0920
I
To Next Page
Loading...
Need help?
General
