Kemppi HiArc M 400A - Gas Test; Selection for Display of Amperes;Wire Feed Speed (Automatic Mode); LCD Display

EN
3.4.4 Gas test
To test the shielding gas ow, press the gas test button once. The shielding gas starts to ow
and stops automatically after 20 seconds.
To interrupt the gas test, press the button again.
3.4.5 Selection for display of amperes/wire feed speed (automatic mode)
A long press (5 secs) of button 11 also switches the display from m/min to amperes.
3.4.6 LCD display
1.
2.
3.
1. Automatic settings
2. Welding parameters
3. Crater ll parameters
HiArc M 400A, M 500A
14