Kemppi MinarcMig 180

To Next Page

To Previous Page

MinarcMig™ Adaptive 180

Figure 3.2. Connecting the gas hose to a typical control valve

1. Connect the hose to the gas bottle’s control valve and tighten the

connector.

2. Adjust the ow rate with the control valve screw. A suitable shielding gas

ow rate is 8-15 l/min.

3. Close the bottle’s valve after use.

NOTE! Use a shielding gas suitable for the material’s welding. Fix the gas

bottle securely in an upright position before installing the control valve.

Kemppi MinarcMig 180 - Page 11