Man-1112 Sigma XT+_23 Page 11 of 52
Table 3 - Compatible detector bases and call points
Model Type Manufacturer Comments
YBN-R/6 STANDARD WITH REMOTE LED Hochiki
YBO-R/4(IS) STANDARD WITH REMOTE LED (I.S.) Hochiki
YBN-R/6SK DIODE BASE Hochiki Must be used with
LCMU
YBO-R/6R STANDARD LATCHING RELAY Hochiki
YBO-R/6RN STANDARD NON-LATCHING RELAY Hochiki
YBO-R/6RS DIODE BASE WITH LATCHING RELAY Hochiki Must be used with
LCMU
ECO1000R STANDARD System Sensor
ECO1000BRSD DIODE BASE System Sensor Must be used with
LCMU
456821-200 STANDARD BASE Apollo
456821-201 DIODE BASE Apollo Must be used with
LCMU
ORB-MB-00001-APO Timesaver Base Apollo
ORB-DB-00003-APO Timesaver Diode Base Apollo
ORB-RB-10004-APO Timesaver Relay Base Apollo
MCP1 470 OHM CALL POINT KAC
CX 470 OHM CALL POINT Fulleon
NCP-T CALL POINT Nittan
ELECTRONICS FREE BASES ALL
Note: LCMU (Line Continuity Monitoring Device) part number K14060 allows call points mounted down line of
detectors that have been removed from diode bases to continue to operate.
Table 4 - Compatible sounders
Model Type Manufacturer Comments
BANSHEE ELECTRONIC VIMPEX
WAFER ELECTRONIC VIMPEX
FIRECRYER RANGE ELECTRONIC VOICE VIMPEX
KOBELL MOTORISED VIMPEX
ASKARI ELECTRONIC FULLEON
ROSHNI ELECTRONIC FULLEON
SQUASHNI ELECTRONIC FULLEON
SYMPHONI ELECTRONIC FULLEON
ELECTRONIC BELL ELECTRONIC FULLEON
CFB BELLS MOTORISED FULLEON
B6 AND B8 BELLS SOLENOID FULLEON
Table 5 - Compatible I.S. barriers
Model Type Manufacturer
MTL5061 DETECTION ZONE GALVANIC ISOLATOR MTL
MTL7778ac ALL SOUNDER CIRCUITS MTL
Note: Use galvanic isolator with Hochiki or Apollo detectors only
To Next Page
Loading...
