Kenwood eXcelon KDC-X792 - G-Analyzer Horsepower Analysis

14
|
KDC-X792/KDC-X692/KDC-MP738U/KDC-MP638U
G-Analyzer Operation
Function of KDC-X792
G-Analyzer Reset
Resets the value of G-Meter, G-Counter and G-
Analyzer Horsepower Analysis.
1 Enter G-Analyzer Reset mode (In Display Type
F)
Select “DISP” > “GMA” > “RESET”.
For how to select Function Control item, refer to
<Function Control> (page 6).
“G-RESET” is displayed.
2 Select the Reset item
Turn the Control knob.
Display Setting
“Meter Reset” Reset the value of G-Meter.
“Power Reset” Reset the value of G-Analyzer Horsepower
Analysis.
“Counter Reset” Reset the value of G-Counter.
3 Determine the item you want to reset
Press the Control knob.
4 Reset the value
Turn the Control knob to select “YES”, and then
press the Control knob.
“Reset OK” is displayed.
5 Exit G-Analyzer Reset mode
Press the [FNC] button.
G-Analyzer Horsepower Analysis
This measures the horsepower and displays graph
and max power. It automatically saves the highest
record.
¤
• Do not use G-Analyzer Horsepower Analysis on the
Public roads.
• Do not use this product in any way that prevents you
from driving safely.
• Follow all driving laws and use common sense when
using this product.
1 Enter G-Analyzer Horsepower Analysis
mode (In Display Type F)
Select “DISP” > “GMA” > “HP”.
For how to select Function Control item, refer to
<Function Control> (page 6).
“HORSEPOWER” is displayed.
Previous max power and record are displayed.
2 Begin measurement
Press the Control knob.
“Ready” is displayed.
3 Start the car.
“Measure” is displayed.
After 15 seconds of measurement, the result is
displayed.
¤
• Pressing the Control knob also begins the measurement.
To prevent danger, push the control knob before starting
the car.
4 To display the maximum power in the section
Push the Control knob towards right or left.
Each time you push the Control knob, the
maximum power in the section is displayed.
5 Exit G-Analyzer Horsepower Analysis mode
Press the [FNC] button.
⁄
• Like your vehicle’s speedometer, G-Analyzer is no more
than a measuring function. The HP or G value measured
by this unit may not be completely accurate due to its
simplified method of measurement. The G-Analyzer is
only for reference and should not be used to confirm the
horsepower specifications of your vehicle.
• Measuring after starting the car lowers the accuracy.
• The record will not be renewed if the measurement is
discontinued.
B64-4048-0000.indb14B64-4048-0000.indb14 08.2.54:22:45PM08.2.54:22:45PM