English
|
27
Preset Memory
Putting the channel in the memory.
1 Select the channel to put in the memory
Push the Control knob towards right or left.
2 Enter Preset Memory mode
Select “P.MEM”.
For how to select Function Control item, refer to
<Function Control> (page 6).
3 Select the number to put in the memory
Turn the Control knob.
4 Determine the number to put in the memory
Press the Control knob.
5 Allow the determined number to take effect
Press the Control knob.
Cancelling the Preset Memory mode
Press the [FNC] button.
⁄
• Only the channel number is stored. Category information
is not stored.
• This function can be operated with [1] — [6] button.
- Press the desired [1] — [6] button for at least 2 seconds.
Preset Tuning
Recalling the channels in the memory.
1 Enter Preset Tuning Select mode
Turn the Control knob.
A list is displayed.
2 Select a desired station in the memory
Turn the Control knob.
3 Recall the station
Press the Control knob.
Cancelling Preset Tuning
Press the [FNC] button.
⁄
• This function can be operated with [1] — [6] button.
- Press the desired [1] — [6] button.
B64-4048-0000.indb27B64-4048-0000.indb27 08.2.54:22:48PM08.2.54:22:48PM
To Next Page
Loading...
Need help?
General
