EasyManuals Logo

Kenwood eXcelon KDC-X792 User Manual

Kenwood eXcelon KDC-X792
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
English
|
37
Troubleshooting Guide
Some functions of this unit may be disabled by
some settings made on this unit.
! Cannot set up the subwoofer.
• Cannot set up the High Pass Filter.
Cannot set up the Fader.
No Audio control effect on AUX.
<Subwoofer output> of <Basic Operation> (page 4)
is not set to On.
The Dual zone function is enabled. <Audio
Setup> (page 24)
! Cannot set up the subwoofer phase.
The Low Pass Filter is set to Through. <Audio
Setup> (page 24)
! Cannot select the output destination of the
subsource in the Dual zone.
Cannot adjust the volume of the rear speakers.
The Dual zone function is disabled. <Audio
Setup> (page 24)
! Cannot register a security code.
Cannot set up Display Illumination Control.
<Demonstration mode Setting> (page 21) is not
turned off.
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
? The Touch Sensor Tone does not sound.
The preout jack is being used.
The Touch Sensor Tone cannot be output from
the preout jack.
? The illumination flashes when the knob or button
is operated.
This is the key illumination effect.
You set this effect in “MENU” > “ILM Effect” of
<Function Control> (page 6).
Tuner source
? Radio reception is poor.
The car antenna is not extended.
Pull the antenna out all the way.
Disc source
? The specified disc does not play, but another one
plays instead.
The specified CD is quite dirty.
Clean the CD, referring to the CD cleaning of the
section on <Handling CDs> (page 31).
The disc is loaded in a different slot from that
specified.
Eject the disc magazine and check the number
for the specified disc.
The disc is severely scratched.
Try another disc instead.
Audio file source
? The sound skips when an Audio file is being
played.
The media is scratched or dirty.
Clean the media, referring to the CD cleaning of
the section on <Handling CDs> (page 31).
The recording condition is bad.
Record the media again or use another media.
? Noise is heard when carrying out Folder Search.
Noise may be produced if folders without audio files
exist continuously in the playing media.
Do not make folders without audio files.
B64-4048-0000.indb37B64-4048-0000.indb37 08.2.54:22:53PM08.2.54:22:53PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kenwood eXcelon KDC-X792 and is the answer not in the manual?

Kenwood eXcelon KDC-X792 Specifications

General IconGeneral
BrandKenwood
ModeleXcelon KDC-X792
CategoryCar Receiver
LanguageEnglish

Related product manuals