Kenwood NX-5200 User Guide

INSTALLING THE microSD MEMORY CARD
.
1
Remove the battery pack.
2
Open the cap.
3
Insert the microSD memory
card.
●
Insert the microSD memory
card with its terminal side
facing the same side as the
front of the transceiver.
●
Insert the microSD memory
card until it clicks into place.
●
To remove the microSD
memory card, push the card
inwards once, then pull it out
straight.
.
Note:
●
microSD memory cards (Class 2 or higher) and microSDHC memory
cards (Class 2 or higher) can be used.
●
SDXC memory cards cannot be used.
●
This transceiver is not guaranteed to operate with all microSD
memory cards.
(Operations are confirmed on memory cards for the following brands:
SanDisk, TOSHIBA and Panasonic.)
●
Use the microSD memory card within the allowable operating
temperature.
●
Do not remove the microSD memory card or turn off this transceiver
while the microSD memory card is being accessed.
●
The waterproof performance is not guaranteed if the microSD
memory card slot cap is not fit into place.
●
Make sure your hands are clean before opening the microSD memory
card slot cap.
Compensation Disclaimer
Data stored on the microSD memory card may be altered or lost due to
problems with this transceiver. We do not accept liability in respect of
the data stored on your microSD memory card, failure to save the data
properly, loss of data, and any direct or indirect damages.
Cap
microSD
memory card
17

Kenwood NX-5200 Specifications

General

IP Rating	IP67
Zones	128
GPS	Yes
Bluetooth	Yes
Voltage Range	7.5V DC ±20%
Operating Temperature	-30°C to +60°C
Frequency Range	136-174 MHz
Battery Life	14 hours (Digital mode)
Digital Protocol	NXDN, DMR
Display	LCD