PRECAUTIONS
●
Do not charge the transceiver and battery pack when they are wet.
●
Ensure that there are no metallic items located between the transceiver
and the battery pack.
●
Do not use options not specified by KENWOOD.
●
If the die-cast chassis or other transceiver part is damaged, do not
touch the damaged parts.
●
If a headset or headphone is connected to the transceiver, reduce the
transceiver volume. Pay attention to the volume level when turning the
squelch off.
●
Do not place the microphone cable around your neck while near
machinery that may catch the cable.
●
Do not place the transceiver on unstable surfaces.
●
Ensure that the end of the antenna does not touch your eyes.
●
When the transceiver is used for transmission for many hours, the
radiator and chassis will become hot. Do not touch these locations
when replacing the battery pack.
●
When water gets into the microphone opening or the speaker grill, the
voice level may become incoherent or distorted. Lightly shake the
transceiver to remove the water from the speaker and/or microphone
before operating the transceiver.
●
Always switch the transceiver power off before installing optional
accessories.
5
To Next Page
Loading...
Need help?
General
