o
Individual <Indcal>
Refer to “Making Individual Calls” {p. 6} {p. 8} .
o
Individual + Short Message <Ind+SD>
Allows you to specify a Unit ID to send short messages.
o
Individual + Status <Ind+ST>
Allows you to specify a Unit ID to send status messages.
o
IP Address
Displays the IP address.
o
Key Delete <KeyDel>
Allows you to delete the Encryption key. Refer to “DELETING THE ENCRYPTION
KEY (AES (SCM*)/ DES (Built-in-DES or SCM*) and Enhanced Encryption
only)” {p. 46} .
o
Key Lock <KeyLck>
Press this key to lock the transceiver keys. Press the key again to unlock the keys.
The Selector, Lever switch as well as the PTT key on an external microphone or a
Bluetooth device still function normally, and the following functions can still be
operated: Backlight, Battery Status, Call Response, Clear, Emergency, Function,
Key Lock, LCD Brightness, Monitor, Monitor Momentary, Squelch Off, Squelch Off
Momentary and Zeroize.
o
Keyset <Keyset>
Allows you to change the active Keyset stored in a Secure Cryptographic Module
(SCM).
o
Language
Allows you to change the language of the text display on the LCD screen and the
language of the voice announcement. Refer to “MULTI LANGUAGE” {p. 53} .
o
LCD Brightness <Bright>
Allows you to adjust the brightness of the LCD backlight depending on the
surrounding lighting conditions.
o
Lone Worker <LoneWk>
Enables or disables Lone Worker function.
o
Low Transmit Power <Low>
Turns Low Transmit Power on or off. When using a channel programmed with
medium or high power, this allows you to change the output power to low.
o
Maintenance <Maint>
Allows you to display the signal strength, site information and Bit Error Rate (BER)
on the LCD when constructing the system or during maintenance.
31
To Next Page
Loading...
Need help?
General
