Kenwood Sovereign VR-5080 User Manual

2
Moving Around
1. STANDBY indicator
2.
POWER ON/STANDBY button
3. PHONES jack
4. SPEAKERS A/B button
5. INPUT MODE button / RF ON/OFF button
6. CD 2/TAPE 2 MONITOR button / RF BAND button
7. LISTEN MODE button /DISPLAY button
8. THX button
9. SOUND button / SET UP button
10. MULTI CONTROL (Up/Down) buttons
11. P. CALL (Up/Down) buttons
12. MEMORY button
13. AUTO button
14. BAND button
15. AV AUX input jacks
What’s on the Front Panel of Your Kenwood Audio-
Video Receiver?
Standby mode
While the standby indicator of the unit is lit, a small amount of current is
flowing into the unit’s internal circuitry to back up the memory. This
condition is referred to as the standby mode of the unit. While the unit is
in the standby mode, it can be turned ON from the Remote Control unit.

Kenwood Sovereign VR-5080 Specifications

General

Channels	5.1
Total Harmonic Distortion	0.09%
Input Sensitivity	200 mV
Signal-to-Noise Ratio	100 dB
Frequency Response	10 Hz - 100 kHz
Digital Inputs	3 Optical, 2 Coaxial
Video Connections	Composite, S-Video
Dimensions	440 x 170 x 420 mm