Kenwood Sovereign VR-5080 User Manual

7
Moving Around
What’s on Remote Control Unit?
Remote controllable range
Remote control unit can be controlled in the range as shown below using
four AA (R6) batteries.
VOLUME CONTROL
2WAY LCD REMOTE CONTROL UNIT
Take care of the following points when using Remote Control unit.
The remote control signal received by the main unit is the RF signal.
The signal sent from the main unit is sent as Infrared signal.
The control distance of the RF remote signal is about 30 ft (10 meters)
provided there is no obstacle.
• Do not install the receiver in a place where the receiver’s remote sen-
sor is exposed to direct sunlight or high-frequency lighting (inverter
type, etc.) fluorescent lamp. Otherwise the remote control range will
be reduced.
• When the remote control range reduces or the Low Battery indicator
(
) will flash in the LCD display, replace all of the four batteries
together.
20 ft
(6 m)
Infrared remote
transmitter
How Do I Use Remote Control Unit?
To select an item:
The displayed items can be scrolled or switched using the LCD cursor
or button.
The selected item is displayed in the reversed color for distinction from
other items.
RF Remote Antenna
IR Sensor
How Do I Use Remote Control Unit?

Kenwood Sovereign VR-5080 Specifications

General

Channels	5.1
Total Harmonic Distortion	0.09%
Input Sensitivity	200 mV
Signal-to-Noise Ratio	100 dB
Frequency Response	10 Hz - 100 kHz
Digital Inputs	3 Optical, 2 Coaxial
Video Connections	Composite, S-Video
Dimensions	440 x 170 x 420 mm