Kenwood Sovereign VR-5080 User Manual

78
Moving Around
Troubleshooting
I can’t receive a radio station
Check that:
• The appropriate antenna is connected. See Chapter One of the Con-
nections and Setup Guide.
• The broadcast band is correct. See “Radio Tuning” on page 44 of
this manual.
• The tuner is set to the correct frequency. See “Radio Tuning” on
page 44 of this manual.
I’m getting a lot of static/interference
• Check whether the receiver or antenna is too close to a TV or other
electrical appliance.
• Adjust the antenna for best reception.
• If you live in an area with weak FM signals, consider a rooftop FM
antenna (available at any home electronics store).
When I press a button to tune to a preset station, the receiver
does not respond
Check whether:
• The receiver has been unplugged for more than three days. If it has,
your settings were cleared from the receiver’s memory. See “My re-
ceiver won’t turn on and the STANDBY indicator is flashing” on
page 76 of this manual.
• The Tuner input is selected. See “Radio Tuning” on page 44 of this
manual.
Receiver/Tuner

Kenwood Sovereign VR-5080 Specifications

General

Channels	5.1
Total Harmonic Distortion	0.09%
Input Sensitivity	200 mV
Signal-to-Noise Ratio	100 dB
Frequency Response	10 Hz - 100 kHz
Digital Inputs	3 Optical, 2 Coaxial
Video Connections	Composite, S-Video
Dimensions	440 x 170 x 420 mm