Kenwood TM-2570A User Manual

Lights during scan operation © Select key mode.
PHONE TONE VOICE
OOg
@ Press to start
scanning.
@ Press to release scanning.
(Scanning can also be re-
leased using the PTT
switch.)
@ Select the channel to ( Set to memory
be locked out.
Lock out indicator
CHL mm OC PHONE TONE VC’
OO OO
@ A star * will appear on the © When the [LO] key is pressed
display when this key is again, the star * will disap-
pressed, indicating that pear and lockout will be re-
lockout has been complet- _ leased.
ed.
18
4-5-2. Programmable band-scan from
the keyboard
The lower limit may be programmed into memory “co”
and the upper limit into memory “U”.
@ Press the M.CH switch to select key mode. The
MEMORY CHANNEL selector lamp will go OFF.
@ Press the [SC] key to initiate scan operation. If scan is
initiated within the limits set in channel “d“ and“ U”,
scan wil! proceed from the currently displayed fre-
quency (within the programmed limits), in 5 kHz
steps. If you initiate scan outside the programmed
limits, scan will proceed outside the programmed
limits, in 5 kHz steps.
@® When the same frequency has been stored in both
memory “d “ and memory “U”. The radio will scan
the entire frequency range of the radio.
4-5-3. Scan direction
During scan operations you can reverse the direction of
scan with the UP and DWN pushbuttons on the micro-
phone. Pressing the DWN key causes scan to proceed
down in frequency. Pressing the UP key causes scan to
increase in frequency.
4-5-4. Scan speed
Scan speed can be increased by holding either the UP or
the DWN key depressed, depending upon the desired di-
rection of scan.
4-5-5. Scan lockout (Skip)
This transceiver has a scan lockout function which al-
lows you to temporarily skip unwanted memory channels
during memory scan.
@ Press the M.CH switch to select the memory mode.
(The MEMORY CHANNEL selector will light.)
@ Select the memory channel to be skipped by using the
MEMORY CHANNEL selector.
@® Press the [LO] key and a star * appears to the left of
the memory channel number.
@ Repeat steps @ and @ to lockout any unwanted
memory channels.
To cancel channel lockout, select the memory channel
to be restored, and press the [LO] key. The star will
disappear.
4-5-6. Scan release
Scanning can be released by any one of the following
operations: Select the most convenient.
© Press the [C] key.
@ Press the PTT switch once.
@ Turn power OFF.
@ Set the PRIO switch to ON.
® Set the F.LOCK switch to ON.

Kenwood TM-2570A Specifications

General

Brand	Kenwood
Model	TM-2570A
Category	Transceiver
Language	English